adhesion strength

基本解釋

The adhesion strength and stripping and splitting prevention measure were also discussed.
同時研究了涂料的粘附強度、防裂、防剝落等措施。
A(continuous) and compact electrode with the three-layer structure is formed at 950℃, and the adhesion strength of Ni electrodes is dependent on the middle layer.
燒結溫度是影響鎳電極致密化過程的重要因素，950℃時形成了連續、致密的三層結構電極，中間層與鎳電極附著強度相關；
The results show that the interfacial adhesion strength increased noticeably for composites of active aramid fiber but the fracture energy of the interface decreased.
實驗結果證明，芳綸表面改性顯著提高了其復合材料界面的粘結強度，相反卻降低了其界面斷裂能。

結合強度
Cross section micrographs and adhesion strength of the coatings were analyzed by TEM and scratch tester. The results show that:both the thickness of physical mixed interface layer and Cr bond layer was reduced significantly with the basic pressure decreased.
利用TEM、劃痕儀分析了不同真空度下鍍層微觀截面形貌與結合強度的變化。
粘接強度

結合強度
Interlayers and transition layers was introduced to improve the adhesion strength of the coatings.
通過引入中間過渡層的方法來提高涂層與基體的結合強度。
附著強度
Effects of the components and contents of binders on the thick film properties have been investigated. It was found that when the glass content was 10%, film adhesion strength achieve maximum (11.6MPa).
研究了玻璃粘結劑組成、含量對金屬化膜層性能的影響,實驗發現當玻璃含量為10%時,Ag導體層與AlN基片之間附著強度最大(11.6MPa);在固含量不變的情況下,隨著玻璃含量的增加,方阻逐漸增大。
物理學
粘合強度
粘著強度
膠粘強度