gear contact ratio

基本解釋

The investigate characteristic of system vibration and effects of contact ratio, gear number on dynamic mesh force were discussed.
在此基礎上分析了不同速度（頻率）對系統振動的影響，并研究了重合度、齒數與系統動態嚙合力之間的關系。
High tooth gear has small module, small pressure angle, and large addendum to enlarge the transverse contact ratio, improve gear strength, and reduce the noise.
細高齒齒輪是采用小模數、小壓力角、大齒頂高來加大端面重合度，達到提高齒輪強度、降低噪聲的目的。
After getting the formula about the normal backlash and the stiffness of the tooth pairs of the gear, the contact ratio and the load correction factor could be obtained.
在獲得齒輪內嚙合傳動的齒側間隙計算公式以后，結合齒對剛度的計算公式，推導出齒輪內嚙合傳動的加載重合度及載荷修正系數。